|
AMCC's 3ware 9650SE SATA II hardware RAID controllers
deliver industry-leading RAID 6 and RAID 5 performance, robust fault tolerance,
and multi-terabyte capacities. A PCI Express host interface, Multi-lane™
connectivity, StorSwitch™ architecture and sophisticated SATA II features drive
this unrivaled performance.
The Best Keeps Getting Better
The 3ware 9650SE PCI Express to SATA II RAID controller pushes AMCC's established
leadership in RAID controller performance to new heights. While 3ware
controllers continue to lead the market in RAID 5 performance, the 3ware 9650SE
outshines the competition as the new standard bearer for RAID 6 performance,
delivering over 800MB/s RAID 6 reads and 600MB/s RAID 6 writes.
Red Hot RAID 6
3ware's parallel XOR RAID 6 parity generation algorithm maximizes RAID 6
throughput, so that RAID 6 enabled 9650SE controllers deliver unequaled RAID 6
performance
3ware 9650SE Features
- 8th-generation
StorSwitch™ non-blocking switched architecture.
- On-board
I/O RISC processor and RAID offload provides true hardware RAID.
- SCSI device driver model to take advantage of the benefits of SCSI using
inexpensive Serial ATA drives .
- Bootable
array support for greater fault tolerance.
- Variable
stripe size for performance tuning by application.
- 64-bit
LBA support.
- ATA
pass-through mode support.
- Up to
512MB DDR2 533 memory with ECC protection. (see table below)
- 32
pooled DMA channels.
- Complete
configuration management suite.
- 3ware BIOS Manager 2 (3BM2) – easy to use BIOS configuration tool.
- 3ware Disk Manager 2 (3DM®2) – browser-based management tool.
- Command Line Interface (CLI) – scriptable configuration tool.
- SNMP
support.
- SMTP
support for email/pager notification.
- ATA/6
and Out of band (OOB) staggered drive spin-up support.
- Auto
carving allows LUNs > 2TB to be divided into multiple units for legacy
operating systems limited to 2TB max. per LUN.
- Battery
Backup Unit (BBU) support.
- Multiple
logical unit sizes and RAID levels on one card.
- Multiple
card support within a system for large storage requirements.
- Hot-swap
and hot-spare support for data availability.
- Dynamic
sector repair for robust data protection.
- S.M.A.R.T.
disk drive monitoring for reliability.
- Emergency
Flash Recovery protects against failed firmware upgrade.
- Drive
activity LED support.
- Online
Capacity Expansion and RAID Level Migration.
- Enhanced
data protection with write journaling for non-redundant arrays and accidental
drive removal.
- Drive
insertion and removal notification.
- Array/Drive
Status and drive identification LED support. (requires 3ware Chassis Control
Unit-enabled backplane)
- Chassis
Control Unit for enclosure management via I2C.
|